New Products

Level: Advance

Kit to build a Zentaurus Rev 1.22. You need only 3 Knobs for shaft 6.35mm(max. diameter to 24mm/ shaft 6,35mm - 0.25"))and a [...]

Kit to build a boogie rectifier emulation . You need only 6 knobs(with a max. diameter of 16mm- 6.4mm shaft) if use a enclosure 1x6 pots, or max. [...]

Level: Advance

Kit to build a digiatal reverb with the BTDR-3 chip. Controls Hall decay, tone and mix. Are required only 3 knobs with max [...]

Hammond console housing for the installation of keyboards, switches and control devices.
Dimensions: 200mm x 300mm x 58mm
Material : 1.25mm [...]

Kit to build digital delay with the famous PT2399 Chip. Pump charge 9--> 18V on board. You need only 3 knobs for shaft 6.35mm (1/4") and a enclosure [...]

Level: Advanced

Kit to build a digital reverb with the new MEK Daughterboard FV-1 1R (24Bit). You need only a case of min. 1590B, 27134 and [...]

Level: Advance

Kit to build a Plexiclone. You need only 5 knobs for 6.4mm shaft with a max. diameter of 20mm if used the template for the [...]

Kit to build a analog 10-Step Sequenzers witht CV and Gate


Released under the creative commons licenses by-sa-4.0
Delivery [...]

Power rating w/o Heatsink: 300/60 Watt,
Max. Voltage: 1900 V
Dielectric strength:3500 VAC
Isolations resistor: 10 Tsd. [...]

Level: Advance

Kit to build modern SLO-100 emulation . You need only 6 knobs (6,4mm)(with a max. diameter of 16mm- 6.4mm shaft) if use a [...]

Kit for building an emulation of the Dumble amp from the 70s. The basic circuit comes from ROG. In this JFET transistors are used instead of tubes to [...]

Kit to build a Tap Tremolo with the TAPLFO3C circuit by Tom Wiltshire --> Electric Druid
You need