PCB for building a digital delay with PT2399 with or without TAP function, use with MAX1044, LTC1044 or ICL7660SCPA, drilled and soldering mask, [...]
Kit to build a germanium fuzz face with negative ground. You need only 2 Knobs (1/4") and a enlosure minimum 1590B.
Inhalt:
1x [...]
Kit to build a Mikroamp. You need only a knob (1/4") and a enclosure e.g 1590B or other
Inhalt:
1x 3PDT switch
1x Mono [...]
Kit to build a extern parallel loop for effects with blend and +20dB boost.
internal doubling of the operating voltage to approx. 16V DC
. [...]
Kit to build a Dynacomp clone. You need only a enclosure e.g. 1590B, 27134PLSA, 1550B or GEH013 and 3 Knobs for shaft [...]
Kit to build a TS808 Clone. You need only a enclosure and 3 knobs for pots with 6,35mm shaft with a max. diameter of 20mm
Contents:
1x [...]
Level: Advance
Kit to build a Zentaurus Rev 1.22. You need only 3 Knobs for shaft 6.35mm(max. diameter to 24mm/ shaft 6,35mm - 0.25"))and a [...]
Kit to build a germanium Fuzz Factory with negative ground. You need only 5 knobs (6mm for 18-teeth shaft) with a max. diameter of 19mm and a [...]
Predrilled enclosure Eddystone 27134PLSA - 111x60x31
incl. 4 screws and 4 adhesive rubber feets
Drills:
3x Potentiometer: Drill [...]
Kit to build a Colorsond(R) Tremolo. You need only two Knobs for shaft with 6,35mm and a max. diameter of 23mm, if used a 1590B enclosure and a [...]
Kit to build your own BluesBro. You need only 3 knobs (max. diameter to 20mm/ shaft 6,35mm - 0.25" for a 1290 predrilled enclosure)and a eclosure of [...]
Circuit board to the making Colorsound Tremolo clone, drilled and solder mask, Measurement 55x35mm fitting for Hammond 1590 B or other, wiring [...]
Enter your shipping information.
Deutsch
