MEK

Kit to build a unidrive Clone. You need only a enclosure and 3 knobs for pots with 6,35mm shaft with a max. diameter of [...]

Kit for building a JHMD-1. The kit is based on the overdrive channel of the Marshall Jackjammer. Well suited for crunch to fat board (almost high [...]

Kit to build a Small Clone Chorus with mod. You need only 3 Knobs for shaft diameter 6.35mm (max. diameter 20mm) and a [...]

Module to select the 8 programs of FV-1 chip (external or internal programs). Compact SMD board with rotary switch 1x8.
Dimensions: [...]

Module to select the 8 programs of FV-1 chip (external or internal programs). Compact 8-pole rotary switch, PCB, pregrommaed PIC
1x [...]

Complete kit for a VCO based on the AS3340. Printed circuit board and design by Kassutronics Finland (Caspar Ockeloen-Korppi)
Front design [...]

Complete kit for a MS-20 VCF clone. Printed circuit board and design by Kassutronics Finland (Caspar Ockeloen-Korppi)
Front design Kassutronic - [...]

Complete kit for a transistor ladder filter (e.g. moog VCF). Printed circuit board and design by Kassutronics Finland (Caspar [...]

Completely assembled board for building a 3-fold footswitch for Marshall 6100.
Pushbuttons are required (momentary OFF-(ON)
For Marshall [...]

Kit for an ADSR generator based on the VCADSR7B from Electricdruid.
Front design UK-electronic
All electrical and mechanical components, [...]

Kit for the construction of an amplifier up to 100W.
Double-sided PCB with silkscreen, dimensions: 50x35mm.
All electronic components [...]

Kit to build a overdrive OD-1+. Based on the old Boss OD-1, with additional tone control. You need only 3 knobs (1/4" max. diameter 20mm) and a [...]