MEK

Kit for the construction of an amplifier up to 100W.
Double-sided PCB with silkscreen, dimensions: 50x35mm.
All electronic components [...]

Kit to build a unidrive Clone. You need only a enclosure and 3 knobs for pots with 6,35mm shaft with a max. diameter of [...]

Webproject of www.freestompboxes.org for the construction of a Weidmann ODD, Thermionic (Friedman BE-OD). Designed by Bajaman New Zealand. Thank [...]

Kit to build a ProCo Rat clone.
You need only 3 knobs knob's for shaft with a diameter of 6,35mm (max. diameter 20mm if use a 1590B enclosure) [...]

Level: Advance

Kit to build a digiatal reverb with the BTDR-3 chip. Controls Hall decay, tone and mix. Are required only 3 knobs with max [...]

Level: Advance

Material composition for the bass overdrive "BassAmuser" from the musicians Board. All components incl. Hammond 1590BB raw [...]

Module for the construction of an amplifier up to 100W.
Prefabricated and tested DMOS amplifier module.
Single-sided PCB with silkscreen, [...]

Kit to build digital delay with the HT8955A and 256K Dram. You need only 3 knobs for shaft 6.35mm (1/4") and a enclosure e.g. 1590BB.
Using the [...]

Sold out!!
Level: Advanced

Attention: this kit is not a beginners project! The voltages can +/- 60V DC and more, and are absolutely [...]

Kit to build a silicon linear booster. You need only a knob (1/4") and a enclosure e.g. 1590A or greater.
Can't powered by a battery if used a [...]

Kit to build a Tap tempo module with LED for the PT-80 delay.
You can use it also with Rebote 2.0, Rebote 2.5, Madbean Cave dweller, Mad [...]

Kit to build a Tap tempo module with LED for the PT-80 delay.
You need only a SPST, SPDT or DPST switch momentary
You can use it also with [...]