MEK

Printboard to build a bass (guitar) compressor from the articel on the musiker-board forum.
Double layer PCB
fit for Hammond 1590 BB, GEH [...]

Double sided PCB to build the Weidmann BEE-ODD project (Friedmann BE-OD) from the FSB Forum.

Dimension:57x48mm

Double sided PCB to build the www.freestompboxes.org Weasel V84. Credits goes to Bajaman Newzealand. Thanks.

Dimension: 87x57.4mm

Kit to build a PIC relay bypass with momentary switch and mute

Content:

1x Soft switch
1x preprogrammed PIC
1x DPDT [...]

Circuit board to build a Brian May Treble Booster. Printboard board drilled, tinned, soldermask. Measurement 53,5 x24mm. Fastening holes 4 mm.

Circuit board to build a Big Muff Pi for all versions. Printboard board drilled, tinned, soldermask. Measurement 61x34mm. Fastening holes 4 mm, [...]

Printboard to build a bor clone, single side, solder mask, silk screen
Dimension: 98x24mm

Printboard to build a bor clone, single side, solder mask, silkscreen. Ground fault, solder a bridge. Identical to the standard Kit
Dimension: [...]

Circuit board to the making Colorsound Tremolo clone, drilled and solder mask, Measurement 55x35mm fitting for Hammond 1590 B or other, wiring [...]

PCB for building a digital delay with HT8955A and DRAM. Delay time approx 0.8ms. Double side pcb, silkscreen, soldermask.
Dimension: [...]

Circuit board to build a Distortion. The PCB can used to build the Distortion DOD250, MXR Distortion+ , YM308 and MXR Microamp. Printboard board [...]

Printboard to build a DOD280 compressor clone. single side, solder mask, Silkscreen
Dimension:55x35mm