UK-electronic

Connection cable for IDC connectors (eg Modular System A-100) 10 pole gray -> 10-pin male to 16-pin male with strain relief.

Kit to build a ProCo Rat clone.
You need only 3 knobs knob's for shaft with a diameter of 6,35mm (max. diameter 20mm if use a 1590B enclosure) [...]

Webproject of www.freestompboxes.org for the construction of a Diezel VH4 simulation. Designed by Bajaman New Zealand. Thank you.
Only 7 [...]

  Digitales Effektmodul

Adapter kit for the SSI2144 4-pole voltage controlled filter. Corresponds internally to the SSM2044. For direct replacement or replacement of the [...]

Assembled adapter SSI2144 4-pole voltage controlled filter. Corresponds internally to the SSM2044. For direct replacement of the [...]

Connection cable for IDC connectors (eg Modular System A-100) 16 pole gray -> 16-pin male to 16-pin male with strain relief.
Length: 20cm

Kit to build a analog 10-Step Sequenzers witht CV and Gate


Released under the creative commons licenses by-sa-4.0
Delivery [...]

Kit to build a unidrive Clone. You need only a enclosure and 3 knobs for pots with 6,35mm shaft with a max. diameter of [...]

Kit to build a Small Clone Chorus with mod. You need only 3 Knobs for shaft diameter 6.35mm (max. diameter 20mm) and a [...]

Kit to build a Tap Tremolo with the TAPLFO3C circuit by Tom Wiltshire --> Electric Druid
You need

Complete kit for a MS-20 VCF clone. Printed circuit board and design by Kassutronics Finland (Caspar Ockeloen-Korppi)
Front design Kassutronic - [...]