MEK

Sold out!!
Level: Advanced

Attention: this kit is not a beginners project! The voltages can +/- 60V DC and more, and are absolutely [...]

PCB for building a digital delay with HT8955A and DRAM. Delay time approx 0.8ms. Double side pcb, silkscreen, soldermask.
Dimension: [...]

PCB for building a Ze(h)ndrive. Single side pcb, silkscreen, soldermask.
Dimension: 46x36mm.

Level: Advance

Material composition for the bass overdrive "BassAmuser" from the musicians Board. All components incl. Hammond 1590BB raw [...]

PCB for building a Unicord SuperFuzz. Single side pcb, silkscreen, soldermask.
Dimension: 56.40x43.50mm.

Level: Advance

Kit to build a digiatal reverb with the BTDR-3 chip. Controls Hall decay, tone and mix. Are required only 3 knobs with max [...]

Kit to build a simply digital reverb with the new Belton chip BTDR-2. You need only a case of min. 1590B and 1 knob for a pot with 6,35mm shaft. [...]

Double sided PCB to build a digital reverb with the Belton/Accutronic chip BTDR-2H-X. PCB fit for 1590B enclosure.

Dimension: [...]

Double sided PCB to build a Autowah (Snowhite). PCB fit for 1590B enclosure.

Dimension: 86x55mm

Kit to build a AutoWah (Snowhite). You need only a enclosure of min. 1590B and 4 knob for a pot with 6,35mm shaft max. diameter of 20mm. [...]

Double sided PCB to build a Tap Tremolo. PCB fit for 1590BB enclosure.

Dimension: 80x53,6mm

Double sided PCB to build a digital reverb with the Belton/Accutronic chip BTDR3-H. PCB fit for 1590B enclosure.

Dimension: 86x55mm