MEK

Circuit board to build a Fuzz Faces with Silicon NPN Transistors/negative gound. Millenium-bypass circuit on board. Circuit board drilled, tinned, [...]

Kit to build digital delay with the famous PT2399 Chip with a tap tempo function. Pump charge 9--> 18V on board. You need only 3 knobs for shaft [...]

Circuit board to the making a mini booster, drilled and solder mask, Measurement 55x35mm fitting for Hammond 1590 B or other, wiring [...]

Circuit board to the making mosfet booster (SHO), drilled and solder mask, Measurement 47x20mm fitting for Hammond 1590 B or other, wiring [...]

Kit to build a treblele booster. Needed becomes only a knob (1/4") and a enclosure.


The treble booster unit is an essential component [...]

PCB for 2 DPDT relays.
can use with:
116-002/ 004
116-008 bis 010
Dimension: 32mm x 32mm

Kit to build a AVR relay bypass with momentary switch

Content:

1x preprogrammed AVR
1x DPDT Latching relay
1x PCB
1x [...]

Kit to build a Tap Tremolo with the TAPLFO2D circuit by Tom Wiltshire --> Electric Druid
You need

Printboard to build a bor clone, single side, solder mask, silk screen
Dimension: 98x24mm

Printboard to build a bass (guitar) compressor from the articel on the musiker-board forum.
Double layer PCB
fit for Hammond 1590 BB, GEH [...]

Complete Kit to build a bass (guitar) compressor from the articel on the musiker-board forum.
*Double layer PCB, 81x81mm
*all electronic [...]

PCB for 2 DPDT relays + 6.35mm jack to switch 2 function .
can use with 5V DPDT relay:
Dimension: 53mm x 35mm