MEK

Kit to build a AutoWah (Snowhite). You need only a enclosure of min. 1590B and 4 knob for a pot with 6,35mm shaft max. diameter of 20mm. [...]

Kit to build your own Ze(h)ndrive clone. You need only 4 Knobs(max. diameter to 20mm/ shaft 6,35mm - 0.25\" for a 1590B predrilled enclosure)and a [...]

Attention! Not a project for beginners

Kit to build the electric druid Multi Flanger by Tom Wiltshire -->

Only available in german!!!

PCB for 8-fach Looper/switch System with MIDI control.
pcb with preprogramed controller.
+ [...]

Kit to build a Distortion Pro V1. You need only 6 knob's for 6.4mm shaft and a max. diameter of 20mm (if used a predrilled enclosure) and a enclosure [...]

Kit to build digital delay with the HT8955A and 256K Dram. You need only 3 knobs for shaft 6.35mm (1/4") and a enclosure e.g. 1590BB.
Using the [...]

Kit to build a Small Clone Chorus with mod. You need only 3 Knobs for shaft diameter 6.35mm (max. diameter 20mm) and a [...]

Level: Advance

Kit to build modern SLO-100 emulation . You need only 6 knobs (6,4mm)(with a max. diameter of 16mm- 6.4mm shaft) if use a [...]

Kit to build John Hollis Zombie Chorus. Needed becomes only 3 knob's for shaft with a diameter of 6,35mm (max. diameter 23mm) and a case e.g 1590BB [...]

Level: Advance

Kit to build a Plexiclone. You need only 5 knobs for 6.4mm shaft with a max. diameter of 20mm if used the template for the [...]

Kit to build digital delay with the famous PT2399 Chip. Pump charge 9--> 18V on board. You need only 3 knobs for shaft 6.35mm (1/4") and a enclosure [...]

Level: Advance

Kit to build a digiatal reverb with the BTDR-3 chip. Controls Hall decay, tone and mix. Are required only 3 knobs with max [...]