Boards for DIY

Double side bus board for A-100 / MOTM systems for installation in rack housings 84TE
- 14 slots for A-100 system
- 12 slots for the MOTM [...]

Circuit board to build a Fuzz Faces with GE-PNP Transistors/negative gound. Millenium-bypass circuit on board. Circuit board drilled, tinned, [...]

Circuit board to build a Distortion. The PCB can used to build the Distortion DOD250, MXR Distortion+ , YM308 and MXR Microamp. Printboard board [...]

Circuit board to the making a fuzz factory clone, drilled and sealed with soldering varnish, fitting for Hammond 1590 B. No off board [...]

Circuit board to the making a mini booster, drilled and solder mask, Measurement 55x35mm fitting for Hammond 1590 B or other, wiring [...]

Printboard to build a bass (guitar) compressor from the articel on the musiker-board forum.
Double layer PCB
fit for Hammond 1590 BB, GEH [...]

Printboard to build a FT OohSeeDee, single side, solder mask
Dimension: 54x356mm

Printboard to build a DOD280 compressor clone. single side, solder mask, Silkscreen
Dimension:55x35mm

PCB for building a Zentaurus, drilled, soldering mask, silk screen. Dimension 85x45mm. Fit for a 1590BB enclosure

PCB for building a bass overdrive "Bass Amuser" of the thread at the musikerboard.
Single side pcb with silkscreen, dimension : [...]

Double sided PCB to build a digital reverb with the Belton/Accutronic chip BTDR-2H-X. PCB fit for 1590B enclosure.

Dimension: [...]

Double sided PCB to build a digital reverb with the Belton/Accutronic chip BTDR3-H. PCB fit for 1590B enclosure.

Dimension: 86x55mm